3shul C350 V4

3shul C350 V4

399,00 € + IVA (inclòs)

4 en estoc

Categories: ,

Descripció

Features:

  • Controller based on the open-source VESC® Project firmware by Benjamin Vedder. (VESC is a trademark owned by Benjamin Vedder).
  • Supports Field Weakening and MTPA (Maximum Torque Per Amp).
  • Ability to create LISP modules from firmware version 6.
  • STM32F4 microprocessor running at 168MHz.
  • Operation with or without motor position sensors, using FOC (Field-Oriented Control) algorithm.
  • Voltage and current measurement on all three phases.
  • Adjustable regenerative braking.
  • Supports Brushless, Brushed, DC motors, and IPM.
  • Intuitive and well-designed user interface.
  • Adjustable PWM frequency.
  • Strong startup torque, even without motor sensors.
  • The motor is used to monitor speed.
  • Control modes include duty-cycle control, current control, position control, and speed control.
  • Motor control interfaces: PPM (RC servo), Analog (ADC1/2), UART, I2C, USB, or CAN-bus (used by the SmartDisplay).
  • Current and Wh consumption monitoring.
  • Optional PPM output, useful for controlling an RC car with a Raspberry Pi or Android device.
  • Adjustable protection settings for:
    • a) Low voltage
    • b) High voltage
    • c) Excessive phase current
    • d) Excessive battery current
    • e) Excessive regenerative braking current (separate for motor and battery current)
    • f) Too rapid duty-cycle changes
    • g) Excessive RPM (Revolutions per minute).
  • When the current limit is reached, a software-based limit strategy is applied while the motor is running. If the current is excessively high, the motor is completely cut off for a short period.
  • RPM limit is software-based.
  • Real-time data monitoring and recording.

Specifications:

  • Dimensions: 135mm (Length) * 75mm (Width) * 45mm (Height)
  • Voltage: 36-88V (8-21S)
  • Current: Max continuous 150A (Battery), 350A (Phase) – These values depend on cooling capabilities and hardware.
  • Supports both BLDC square wave and FOC sinusoidal signals.
  • Firmware: Up-to-date (firmware update supported).
  • ERPM: 150,000.
  • Control Ports: USB, CAN, UART, Bluetooth (built-in).
  • Motor sensors supported: ABI, HALL, AS5047, AS5048A, Sensor-less.
  • Motor control ports: PPM, ADC, NRF, UART.
  • Copper Bus bars: 10mm diameter.
  • Integrated Gyroscope and Accelerometer: BMI160.
  • Built-in 12V 3A power supply.
  • Programmable: Yes.

Productes relacionats